Screen it.
Blow it off.
Tape off the boxes.
Patches over the boxes.
Pull the cloth.
Cut the cloth.
Roll the cloth.
Laminates down.
Make sure you have your tools ready.
Clean your bucket.
Pull the resin.
Pour the hardener.
Mix. Well.
Place your logos.
Roll cloth back.
Wet out fin patches.
Any other logos down now.
Roll cloth back.
Set the cloth down the stringer.
Wet out the flats. Spread well.
Wet out the lap line.
Tuck the lap line.
Fix the strings.
Check for over or under saturation.
Watch the air in the nose bead.
Make sure it doesn’t drain out.
Let it go off.
Grind the lap line.
Place hip patches.
Pull cloth.
Cut to speed edge.
Pull cloth again.
Cut with a lap line.
Roll cloth.
Laminates down.
Clean your bucket and tools.
Pull resin.
Add hardener.
Mix. Well.
Logos down.
Roll cloth back.
Set cloth down the stringer.
Wet the flats. Spread extra well.
Wet the lap line.
Tuck the lap line.
Fix the strings.
Check for over or under saturation.
Make sure it doesn’t drain out.
Let it cure.
Glassing.
Cheers,
hwilsin
Drew Stanfield